Chipper 170, hydraulic infeed with pump and tank
Chipper with hydraulic infeed, chips trunks up to 17.5 cm ø
Hydraulically fed chipper with high capacity
• CE labelled • Wood dimensions up to 17.5 cm
• Own hydraulic system with tank and PTO-operated pump
• Hydraulic infeed in four positions: stop, forwards, backwards and stop
• Emptying flap at the base
• Safe transportation when infeed is closed in transport mode
• Adjustable infeed speed • Deep infeed hopper with stop lever
• Good accessibility for easy maintenance
• Ejection hopper height: 228 cm
• Infeed hopper opening: 66 x 89 cm
• Infeed hopper next to drive rollers: 18 x 31 cm
• Feed-in rollers: Horizontal pattern with 1 hydraulic motor per roller
• Ejector chute:Adjustable 360° with adjustable ejector angle
Kellfri's WC17H Chipper for wood dimensions up to 17.5 cm, with heavy-duty cutting disc, hydraulic feeder rollers, pump and tank.
The chipper, with its own hydraulic system, is ideal for operation with both PTO 540 rpm and 1000 rpm. The hydraulic system means that the chipper's valves and system are not overloaded, regardless of your tractor's rpm. Depending on the type of wood and materials to be chipped it can be a good idea, for the best chipping performance and capacity, to use as high a speed as possible. PTO 540 rpm is the minimum speed for good chipping, and the maximum speed is 1000 rpm.
If the logs and branches are wet, you should delimb most of the branches before using the chipper. If the material is dry, just go ahead and use it without delimbing. The chipper is fitted with a removable branch crusher as standard.
Adjustable infeed speed, powerful bearings, forward/reverse feeder roller functionality and deep infeed hopper for safe machine feeding. Adjustable discharge chute and ejection angle adjustment for even spreading or exact trailer filling.
Sturdy cutting disc with holes so that it can be locked for maximum safety during maintenance. Branch crusher for best results when chipping trees with branches. On the cutting disc there are 4 blades with double tempered cutting edges.
The chipper has an adjustable counter bar for desired chip size. It is important to set it to suit the blades on the cutting disc and for best results depending on the type of wood you have.
For maximum control, functionality and safety, infeed is done with a lever: stop, forwards, backwards and stop.
The ejector chute is generously sized, with an inner dimension of 18 cm.
Both the upper and lower feed-in rollers have horizontal feed-in patterns for the best possible grip on the logs that are being chipped. With thick logs, always start with the thin end, where the rollers can grip most easily. The feed-in rollers are spring loaded for maximum grip and feed-in. Each roller is operated by its own hydraulic motor.
Splash protection in the infeed hopper. The infeed opening to the cutting disc is 18 x 31 cm.
Toolkit for service and maintenance included.
|Engine Power||40-100 hp|
|Cutting disc||Ø 740 mm, 105 kg|
|Hydraulic oil tank||24 l|
|Blades||4 + 1|
|L x W x H||Transport mode: 21110 x 1430 x 2280 mm
Operating mode: 2750 x 1630 x 2280 mm
|Three-point connection||Category 2|
|Timber diameter max.||175 mm|